LG WT7005C Serie Manuel D'utilisation page 28

en-us_main.book.book Page 28 Tuesday, March 21, 2023 2:53 PM
28 TROUBLESHOOTING
Problem
The control lock function is on to prevent anyone from changing cycles or operating
or Control Lock
CL
the washer.
LED on
• Turn off the control lock function in the control panel. See Control Lock under Options
CONTROL LOCK
FUNCTION
Special drain feature
or Rinse+Spin LED
dr
blinks
• If the washer is paused during a cycle for more than 4 minutes, the cycle will be canceled
DRAIN FEATURE
• This is not an error code. It indicates that the drain function is operating.
Lid is not closed properly.
or Door Lock and
dE
Control Lock LEDs
• Close the lid properly.
blink
• If the lid is closed and this error message is still displayed, call for service.
LID ERROR
Lid is not locked properly.
or Door Lock LED
dL
blinks
• Make sure that the lid is closed properly and press the Start/Pause button. You can hear
LID LOCK ERROR
• Make sure that nothing is caught under the lid, including shipping material or clothing.
• Make sure that the latch mechanism is fully retracted.Make sure that the latch mechanism
• If the lid is closed and this error message is still displayed, call for service.
Foreign objects such as coins, pins, clips, etc., are caught between the pulsator and the
or Extra Rinse
LE1
inner tub.
and Cold LEDs bink
• Turn the washer off then on again. Press the Spin button without selecting a cycle to drain
FOREIGN OBJECT
ERROR
• When the Spin cycle is completed, empty the tub and find and remove any objects caught
• Always check pockets, etc., before washing to prevent error codes or damage to the
• For some models,
It is time to run the Tub Clean cycle.
or Tub Clean LED
tcL
blinks
• This is not an error code. It indicates that the Tub Clean cycle is running or needs to be run
TUB CLEAN ALARM
• For some models,
The washer has detected an out of balance load.
vb
• This display is for your information only, and no action is required. If the washer detects a
UNBALANCE
DETECTION
• As a result, the cycle will take longer than initially estimated.
Control error
or Rinse+Spin and
tE
Warm LEDs blink
• Unplug the washer and wait 60 minutes. Reconnect power and try again.
TEMPERATURE
• If the error code is still displayed, call for service.
SENSOR ERROR
Water level is too high due to a faulty water valve.
or Rinse+Spin and
FE
Cold LEDs blink
• Close the water faucets, unplug the washer, and call for service.
OVERFLOW ERROR
The water level sensor is not working correctly.
or Hot LED blinks
PE
• Close the water faucets, unplug the washer, and call for service.
PRESSURE SENSOR
ERROR
and Extra Functions.
and any water remaining in the tub will be drained.
the locking sound to lock the lid in the beginning of the cycle. The washer will not operate
unless the lid is locked.
is fully retracted.
and spin the load.
in the pulsator.
washer or clothing.
is displayed first, then the
LE
to clean the washer tub.
is displayed first, then the
tc
load that is too far out of balance to spin, it will display this code while it is attempting to
rebalance the load. The washer will add water and try to redistribute the load
automatically.
Possible Cause & Solution
is displayed.
1
is displayed.
L