SilverCrest SFW 350 D2 Mode D'emploi page 30

5) Place your selected cutting disc
the fixings on the cutting disc
grinder casing
6) After everything has been correctly assembled, screw the ring clamp
back on hand-tight.
7) The ready-assembled meat grinder casing
connector to the motor unit
– Insert the meat grinder casing
arrow on the meat grinder casing
motor unit
– Lightly press the meat grinder casing
the feeding shaft on the meat grinder casing
(Fig. B) so that the arrow on the feeding shaft points to the symbol
When the meat grinder casing
springs out.
– Finally, place the feeding tray
– To dismantle it, press the locking button
to the right (Fig. B)
Assembling the sausage stuffer attachment
Unfold the fold-out side - there you will find the step-by-step illustrations for as-
sembling the appliance.
1) Remove the meat grinder casing
meat grinder".
2) Dismantle all parts which are fitted to/in the meat grinder casing
clean them.
3) Coat all metal parts with cooking oil.
4) Put the transport screw
the meat grinder casing
5) Insert the sausage disc
located in the openings in the meat grinder casing
6) Then place the sausage stuffer attachment
7) Screw the ring clamp
8) Assemble the meat grinder casing
meat grinder".
SFW 350 D2
into the meat grinder casing
are located in the openings in the meat
.
:
into the motor unit
. The locking button
engages, the locking button
on top of the feeding funnel.
. You can now pull the meat grinder casing
as described under "Assembling the
, the spring
.
so that the fixings on the sausage disc
on hand-tight.
as described under "Assembling the
is connected by a bayonet
such that the
lies against the symbol
presses itself in (Fig. B).
in and at the same time turn
into the middle position
and turn the feeding funnel
and the cross blade
.
before the sausage disc
GB │ IE
so that
on the
.
out.
and
back into
are
.
│ 27 ■