S&P CTB ECOWATT PLUS Mode D'emploi page 41

6.4. GENERAL PARAMETERS
Once the wiring is done, turn on the device using the ON/OFF switch. When connecting the unit it will appear some screens:
L L anguage:
E E NGLISH H OK
OK
After choosing the language, a screen with the following information will appear:
S S i:xxxPa a x%
S S c:100Pa a C:1
Si: xxx Measured value (units depend on operation mode)
Sp/Sc: xxx Set point programmed
X% Fan speed in % (on high speed))
C: 1 Fan number if connected to network
Pressing the button can access the second screen of information:
R R PM:xxx x InD:0
R R ele:0 0 C:1
RPM: xxx Fan speed (TACOM terminals connected is required)
Rele: 0 It Indicates if the alarm output relay is connected (0: offl ine output; 1: output connected)
InD: 0 Digital input (J11 night mode or Min/Max)(0: offl ine output; 1: output connected)
C: 1 Communication cannel used (de 1 a 247)
6.5. STARTING THE SYSTEM
Once done the wiring and confi guration of existing units, proceed to the system power supply.
When connecting the unit, it will appear the initial screen with Software version, after 3 seconds will initiate the connection
with number of memorized unit. If communication is successfully, it will appear the fi rst information screen. Corresponding
screen of PI PRESSURE mode will appear by default:
Idioma:
CASTELLANO
I
Si: 100 Pa 100%
S S i:100 0 Pa a 100%
Sp: 100 Pa C:1
S S p:100 0 Pa a C:1
S2: 30%HR 21%
S S 2: : 30%HR 2 2 1%
C:1
C C :1
Langue:
FRANCAISE
I
3
Si: 100 m /h 100%
S S i:100 0 m3/h h 100%
3
Sp: 100 m /h C:1
S S p:100 0 m3/h h C:1
IN_D:ON 21%
I I N_D:ON 2 2 1%
C:1
C C :1
Sprache:
DEUTSCH
41
EN