Expondo Stamos S-MIG160DS Manuel D'utilisation page 41

9) Press the manual wire feed button and wait for the wire to slide out.
CAUTION! Getting the wire out of the burner requires applying power to the unit.
10) Close the spool housing cover.
CAUTION! When inserting the wire into the gun, do not point the gun at yourself or at other people.
Do not place your hand, e.g., in front of the tip, as the cut end of the wire is very sharp. Also, keep
your fingers away from the feed roller, as this may cause your fingers to be pinched between the
rollers.
11. Disposal of the packaging
Please keep all packaging material (cardboard, plastic strips and polystyrene foam) to ensure that the
unit is protected during shipment, should it become necessary to send it to a service center!
12. Transport and storage
When transporting the unit, protect it from shocks and tipping over, and do not place it "upside
down". Store the unit in a well-ventilated room where dry air is present and corrosive gases are not
present.
13. Cleaning and maintenance
Pull the mains plug before each cleaning and when the unit is not in use and cool the unit
completely.
Use only non-corrosive cleaning agents for cleaning the surfaces.
Do not spray the unit with a stream of water or immerse it in water.
Make sure that no water enters through the ventilation openings in the casing.
Clean the ventilation openings with a brush and compressed air.
After each cleaning, all the parts should be dried well before the unit is used again.
Store the unit in a dry and cool place protected from moisture
and direct sunlight.
- Remove dust regularly with dry and clean compressed air.
14. Regular inspection of the device
Check the unit regularly for damage. If this is the case, stop using the unit. Please contact your dealer
immediately for repair.
What should I do if a problem occurs?
Please contact your dealer and have the following information ready:
- Invoice number and serial number (the serial number is indicated on the rating plate).
• Potentially a photo of the defective part.
The service technician will be able to better determine what the problem is if you describe it as
precisely as possible. faults! The more detailed you are, the faster they can help you!
NOTE: Never open the device without consulting customer service. This can lead to loss of warranty