Expondo Stamos S-MIG160DS Manuel D'utilisation page 33

The default parameter for adjustment is the welding current. To adjust the other parameters, use the
MENU button or in the "Volt |" Speed ".
When the left display shows the message corresponding to a given welding parameter, it is possible
to adjust this parameter with the adjustment knob.
SYNERGIC MIG/MANUAL MIG mode
In the standby mode, press the MENU button to enter the induction adjustment mode. The
•
left display will show "ind".
• Press the MENU button again to enter the 2T/4T mode selection. The left display will show
"StP".
• Press the MENU button again to enter the HOT START mode adjustment. The left display will
show "H5."