Complete Installation; Range Hood Use; Range Hood Controls - KitchenAid LIB0098810D Instructions D'installation Et Guide D'utilisation Et D'entretien

2. Secure the bottom of the duct with two 4.2 x 8 mm screws.
The range hood is designed to remove smoke, cooking
vapors and odors from the cooktop area. For best results,
start the hood before cooking and allow it to operate several
minutes after the cooking is complete to clear all smoke and
odors from the kitchen.
The hood controls are located on the front side of the canopy.
H
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct cover
C. Control panel
D. Light switch (ambient lighting)

RANGE HOOD USE

A
B
C
D
E
F
G
E. Glass canopy
F. Perimetric cover
G. LED lights
H. Metal grease filters (located
behind the perimetric cover)

Complete Installation

1. For non-vented (recirculating) installations only, install
charcoal filters over metal grease filter. See the "Range
Hood Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light.
See the "Range Hood Use" section.
NOTE: To get the most efficient use from your new range
hood, read the "Range Hood Use" section.

Range Hood Controls

B
A
A. Blower speed maximum button
B. Blower speed medium button
C. Blower speed minimum button
D. Blower off button
E. On/Off LED task light button
Operating the LED task light
The On/Off light button controls both lights. Press once
for on and again for off.
Operating the blower
The Blower Speed buttons turn the blower on and control the
blower speed and sound level for quiet operation. The speed
can be changed anytime during fan operation by pressing the
desired Blower Speed button.
The Blower Off button turns the blower off.
Operating the Ambient Lighting
The switch controls the ambient lighting.
1. Press to the left to turn Auto on.
2. Press to the right to turn Ambient Lighting on.
3. Press to the center to turn Ambient Lighting or Auto off.
NOTE: When the Ambient Lighting is placed in the Auto
setting, a sensor will automatically sense if it is dark in the
area around the range hood. The Ambient Lighting will turn
on and stay on until it senses there is enough light in the area
around the range hood, or the Ambient Lighting switch is
placed in the on or off position.
C D E
11