yeep.me WEEK Mode D'emploi page 13

EN
3.2. UNPACKING AND ASSEMBLING THE DEVICE
To unpack the product, it is recommended to have a clear surface that is large enough
to unpack and prepare the device. Take the device out of its packaging, making sure
to not injure yourself or damage other products or your surroundings. Have someone
help you if the product is too heavy for you to handle on your own (the weight of the
device is indicated on the packaging).
An adult must unpack and assemble the device.
Mounting the pedals :
Use the R (right) and L (left) markings to identify them.
1. Mount the right pedal on the right crank arm. Tighten the pedal clockwise using the
wrench provided.
2. Then screw the left pedal onto the left crank arm counterclockwise.
Mounting the handlebar :
1. First orient the handlebars in the right direction.
2. Tighten the fixing screw on the stem using the wrench provided.
3. Check that the handlebars are correctly oriented.
Assembly and adjustment of the saddle:
Loosen the nut on the seat post clamp to be able to change the height of the seat
post in the frame.
Select a height and tighten the seat post clamp nut. When adjusting the saddle to
its lowest position, make sure that the saddle does not touch any component of the
bicycle such as the battery cover. Also, be sure not to exceed the minimum seat tube
insertion mark. This insertion mark should never be visible when using the bike.
IMPORTANT : To determine your saddle height, sit on the bicycle and place a heel on
the pedal in the down position with the crank parallel to the seat post. When your leg
is extended the saddle height is correct.
13