Télécharger Imprimer la page

Philips CE233 Manuel De L'utilisateur page 9

Masquer les pouces Voir aussi pour CE233:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 63
3 Install the car
audio system
Caution
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.
These instructions are for a typical installation.
However, if your car has different requirements,
make the adjustment accordingly. If you have
any question regarding installation kits, consult
your local retailer.
Note
This system is designed for negative ground (earth) 12V
DC operation only.
Always install this system in the car dashboard. Other
locations can be dangerous as the rear of the system
heats up during use.
To avoid short-circuit: before you connect, make sure
that the ignition is off.
Make sure that you connect the yellow and red power
supply leads after all other leads are connected.
Make sure that all loose leads are insulated with
electrical tape.
Make sure that the leads do not get caught under
screws iron parts that will move (e.g. seat rail).
Make sure that all ground (earth) leads are run to a
common ground (earth) point.
Use only the supplied mounting hardware for a safe
and secure installation.
Improper fuses can cause damage or fire. When you
need to change the fuse, consult a professional.
When you connect other devices to this system, make
sure that the rating of the car circuit is higher than the
total fuse value of all the connected devices.
Never connect speaker wires to the metal body or
chassis of the car.
Never connect speaker wires with stripes to one
another.
All manuals and user guides at all-guidesbox.com
Connect wires
Make sure that all loose leads are insulated with
electrical tape.
Consult a professional to connect wires as instructed
below.
1
Check the car's wiring carefully and connect
them to the the ISO male connectors.
a
b
c
d
e
f
g
h
i
Note
ISO male
Connect to
connectors
Green strip, black-
Rear left speaker
edged green strip
White strip, black-
Front left speaker
edged white strip
Gray strip, black-
Front right speaker
edged gray strip
Purple strip, black-
Rear right speaker
edged purple strip
Red strip
Ignition key +12V
DC when ON/ACC
Blue strip
Motor/electric
antenna relay
control lead
White-edged blue
Amplifier relay
strip
control lead
Black strip
Ground
Yellow strip
To the +12V car
battery which is
energized at all times
EN
7

Publicité

loading