5. CHARGING PROCEDURE (FIG. F)
LED BAR
Green flashing
Flashing blue
Blue
Flashing Blue/Green
Green flashing
6. ALARMS
In the event of an alarm, the led bar turns red. The possible causes and solutions follow.
CAUSE
The emergency button was pressed.
Voltage too high.
Voltage too low.
Overcurrent.
Short circuit.
Short circuit on control circuit.
Charging station ready.
Vehicle disconnected.
Charging connector inserted in the vehicle socket.
Pass the card through the dedicated area to start the charging process.
Charging in progress.
To interrupt charging, pass the card again in the dedicated area.
Charging complete.
Charging connector disconnected from the vehicle socket.
Place the cable back on the specific cable winder.
Turn the switch clockwise.
Check the power supply voltage.
Check the power supply voltage.
Remove the charging connector from the socket of the vehicle and repeat the
charging procedure.
Remove the charging connector from the socket of the vehicle and repeat the
charging procedure.
Remove the charging connector from the socket of the vehicle and repeat the
charging procedure.
- 6 -
DESCRIPTION
SOLUTION