Publicité
Les langues disponibles
Les langues disponibles
Adjusting setup items
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until the desired
item appears, then press it.
3
Rotate the control dial to select the
setting, then press it.*
The setting is complete.
4
Press
* For CLOCK-ADJ and BTM settings, step 4 is
not necessary.
The following items can be set depending
on the source and setting:
CLOCK-ADJ (Clock Adjust) (page 5)
CT (Clock Time)
Activates the CT function: "ON," "OFF"
(page 10).
BEEP
Activates the beep sound: "ON," "OFF."
CAUT ALM*
Activates the caution alarm: "ON,"
"OFF" (page 5).
AUX-A*
(AUX Audio)
1
Activates the AUX source display: "ON,"
"OFF" (page 23).
AUTO OFF
Shuts off automatically after a desired
time when the unit is turned off: "NO,"
"30S (Seconds)," "30M (Minutes)," "60M
(Minutes)."
REAR/SUB*
1
Switches the audio output: "SUB-OUT"
(subwoofer), "REAR-OUT" (power
amplifier).
DEMO (Demonstration)
Activates the demonstration: "ON,"
"OFF."
22
(BACK).
(Caution Alarm)
1
DIMMER
Changes the display brightness.
– "AT": to dim the display automatically
when you turn lights on. (Available only
when the illumination control lead is
connected.)
– "ON": to dim the display.
– "OFF": deactivate the dimmer.
COLOR (Preset Color)
Selects the preset color of the display and
buttons on the main unit (page 17).
CUSTOM-C (Custom Color)
Selects a preset color as a basis for
further customizing (page 17).
SND SYNC
Selects the color with sound
synchronization: "ON," "OFF."
WHT MENU
Sets the effect when the source is
switched: "ON," "OFF."
START-WHT
Sets the start up color: "ON," "OFF."
M.DISPLAY (Motion Display)
– "SA": to show moving patterns and
spectrum analyzer.
– "OFF": to deactivate the Motion Display.
AUTO SCR (Auto Scroll)
Scrolls long items automatically: "ON,"
"OFF."
ZAP TIME (Zappin Time)
Selects the playback time for the
ZAPPIN function.
– "Z.TIME-1 (about 6 seconds),"
"Z.TIME-2 (about 15 seconds),"
"Z.TIME-3 (about 30 seconds)."
ZAP BEEP (Zappin Beep)
Has the beep sound between track
passages: "ON," "OFF."
LPF FREQ*
(Low Pass Filter Frequency)
2
Selects the subwoofer cut-off frequency:
"50Hz," "60Hz," "80Hz," "100Hz,"
"120Hz."
Publicité
