Publicité
Les langues disponibles
Les langues disponibles
Tip
The equalizer curve setting can be memorized for
each source.
Customizing the equalizer
curve — EQ7 Setting
"CUSTOM" of EQ7 allows you to make
your own equalizer settings.
1
Select a source, then press the select
button.
2
Rotate the control dial until "EQ7
SETTING" appears, then press it.
3
Rotate the control dial until "BASE"
appears, then press it.
You can select an equalizer curve as a
basis for further customizing.
4
Rotate the control dial to select the
equalizer curve, then press it.
5
Setting the equalizer curve.
Rotate the control dial to select the
frequency range, then press it.
BAND1: 63 Hz
BAND2: 160 Hz
BAND3: 400 Hz
BAND4: 1 kHz
BAND5: 2.5 kHz
BAND6: 6.3 kHz
BAND7: 16.0 kHz
Rotate the control dial to adjust the
volume level, then press it.
The volume level is adjustable in 1 dB
steps, from -6 dB to +6 dB.
Repeat steps and to adjust other
frequency ranges.
6
Press
The equalizer curve is stored in
"CUSTOM."
20
(BACK) twice.
Optimizing sound by Time
Alignment — Listening
Position
The unit can simulate a natural sound field
by delaying the sound output from each
speaker to suit your position.
The options for "POSITION" are indicated
below.
FRONT L (): Front left
FRONT R (): Front right
FRONT (): Center front
ALL (): In the center of
your car
OFF: No position set
You can also set the approximate subwoofer
position from your listening position if:
– the audio output is set to "SUB-OUT"
(page 22).
– the listening position is set besides "OFF."
The options for "SET SW POS" are
indicated below.
NEAR (): Near
NORMAL (): Normal
FAR (): Far
1
During reception/playback, press the
select button.
2
Rotate the control dial until "SET
POSITION" appears, then press it.
3
Rotate the control dial to select from
"FRONT L," "FRONT R," "FRONT" or
"ALL," then press it.
4
Rotate the control dial until "SET SW
POS" appears, then press it.
Publicité
