Publicité
Les langues disponibles
Les langues disponibles
English
18
Pumping instructions
Warning: Before you remove the pump body from your breast, always switch off the
breast pump to release the vacuum.
Warning: Do not continue pumping for more than 5 minutes at a time if you do not
succeed in expressing any milk. Try to express at another time during the day.
Warning: If the process becomes very uncomfortable or painful, stop using the pump
and consult your healthcare professional.
Caution: If discomfort is felt, then suction can be broken by inserting a finger between the breast
and the flange.
Note: If you regularly express more than 125 ml/4 fl oz per session, you can purchase and use a
260 ml/9 fl oz Philips Avent Natural bottle to prevent overfilling and spillage.
1. Wash your hands
thoroughly with soap
and water and make
sure that your breast is
clean.
5. Use the 'level up' and
'level down' buttons to
change the suction level
to your preference.
2. Place the breast pump
kit onto your breast.
Make sure that you
center your nipple.
90 sec.
6. After 90 seconds the
breast pump will switch
smoothly to expression
mode and slowly
increase its vacuum to
the last used expression
suction level (or level 11
when used for the first
time).
3 sec.
3. Press and hold the
on/off button until the
device switches on. The
indicator lights go on to
indicate that the device
is in stimulation mode.
7. If your milk starts
flowing earlier or if you
want to switch from
expression to stimulation
mode, you can switch
modes with the mode
selection button.
4. The breast pump starts
in stimulation mode and
slowly increases its
vacuum to the last used
stimulation suction level
(or level 5 when used for
the first time).
8. Briefly press the on/off
button if you want to
pause. To continue,
briefly press the on/off
button again.
Publicité
