5 min.
1. Fill a household pot
with enough water to
cover all parts and place
all parts in the pot. Let
the water boil for
5 minutes. Make sure the
parts do not touch the
side of the pot.
Using the breast pump
Flange size
The Philips Avent single/double electric breast pump Advanced has a soft, active flange. There is only one
flange size. It gently stimulates your nipple to trigger milk flow. The flange is made of flexible silicone, fitting
nipple sizes up to 30 mm/1.18 in.
Assembling the breast pump
Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling
them, they can be very hot. To prevent burns, only start assembling the breast pump
when disinfected parts have cooled down.
Warning: Wash your hands thoroughly with soap and water before you touch breast
pump parts and breasts to prevent contamination. Avoid touching the inside of
containers or lids.
Caution: Before each use, visually inspect the individual components for cracks, chips, tears,
discoloration or deterioration. In the event that damage to the device is observed, discontinue use
until the parts have been replaced.
Caution: Inspect the tubing. If you find condensation in the air tube, wash and dry it immediately
or replace the tubing. If you see breast milk inside the tubing or tubing connector, do not attempt to
wash, clean or disinfect the tubing or tubing connector. Instead, contact the manufacturer.
2. Allow the water to
cool down.
3. Gently remove the
parts from the water.
Place the parts on a clean
surface/tea towel or
drying rack to air-dry.
English
4. Store the dry items
safely until needed.
Ensure the clean pump
parts, bottle brushes and
wash bowls have air-
dried thoroughly before
storing. Items must be
completely dry to help
prevent germs and mold
from growing. Store the
dry items in a clean,
protected area.
15