Pioneer SUPER TUNER III DEH-P9300 Mode D'emploi page 14

Tuner
D
isplay and indicators
FORM 1
q
FORM 2
q
qBand
wLOC indicator
ePreset number
rFrequency
tStereo indicator
B
asic operation
1. Press SOURCE to select the tuner.
Press SOURCE until "Tuner" appears.
2. Press VOLUME to extend the VOLUME
outward.
• When you press VOLUME, it extends out-
ward so that it becomes easier to turn. To
retract VOLUME, press it again.
3. Turn VOLUME to adjust the volume.
13
w e
r t
e w t
r
4. Press BAND to select the desired band.
Press BAND repeatedly to switch between
the following bands:
FM-1 = FM-2 = FM-3 = AM
5. Press 2 2 or 3 3 to tune in to a station.
The frequencies move up or down step by
step.
• If you press and hold 2 or 3 for about one
second and release, you can perform seek
tuning. Seek tuning lets you skip broad-
casting stations until a broadcast strong
enough for good reception is found.
• If you press and hold 2 or 3, you can skip
broadcasting stations. Seek tuning starts
as soon as you release the button.
Note:
• The stereo indicator "
tion is selected.
S
toring and recalling broadcast
stations
If you press any of the buttons 1 – 6, you can
easily store up to six broadcast stations for later
recall.
Storing broadcast stations
1. Press NEXT to display "1" – "6".
Press NEXT until "1" – "6" appears.
2. When you find a station that you want to
store in memory, press and hold any of
the buttons 1 – 6 until the preset number
stops flashing.
The station is stored in memory under the
selected button.
Note:
• Up to 18 FM stations, six for each of the three FM
bands, and six AM stations can be stored in memo-
ry.
" lights when a stereo sta-