Mopar 82212137 Mode D'emploi page 19

19
• Wait for the WCM/WIN to update it's configuration
• Once the WCM/WIN configuration is complete, select "NEXT"
• Select "NEXT"
• Note On­Screen instructions and select the "FINISH" button
TEMPORARY REMOTE START DISABLE
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
CAUTION: Read all notes and cautions for programming procedures.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select the "TIPMCGW"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight and select "TEMPORARY REMOTE START DISABLE"
• Note On­Screen instructions and select the "NEXT" button
• Select the "DISABLE" button to activate the remote start function
• Select "YES" to reset the module and exit the routine, select "NO" to toggle the value back
• Select "FINISH"
CLEAR ALL DTC'S
NOTE: The wiTECH diagnostic application is the preferred method for clearing all DTC's.
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
ACTIVATE THE REMOTE START
To activate the remote start the vehicle must be driven at least 35 MPH.
With the vehicle off, and the doors closed and locked, verify the remote start is functioning properly.
4280274
Sep 30, 2010 K6860943 REV 1