Publicité
Les langues disponibles
Les langues disponibles
18
ECU RESET
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
CAUTION: Read all notes and cautions for programming procedures.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select "WIRELESS CONTROL MODULE (WCM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "RESET ECU"
• Note OnScreen instructions and select the "NEXT" button
• Select "FINISH"
PEM MODULE PROGRAMMING
NOTE: Perform this procedure on vehicles equipped with "Key N Go" push button ignition.
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
CAUTION: Read all notes and cautions for programming procedures.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select the "PASSIVE ENTRY MODULE"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "PEM REPLACED"
WINDOW CALIBRATION
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
NOTE: Vehicles equipped with the auto up feature must have the windows calibrated after a battery disconnect.
NOTE: The door must be completely closed when starting this step.
1. Sit in the driver seat and close the door.
2. Lower the window part of the way down.
3. Run the window to the full up position and continue to hold the switch for an additional two seconds.
4. Run the window to the full down position and continue to hold the switch for an additional two seconds.
5. Raise the window to the full up position.
6. Repeat the steps for the remaining windows.
UPDATE PRESSURE THRESHOLDS
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
NOTE: The vehicle must be driven before the TPMS light will turn off.
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Have the vehicle PIN readily available before running the routine
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select the "FCMCGW"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight and select "UPDATE PRESSURE THRESHOLDS"
• Note OnScreen instructions and select the "NEXT" button
• Verify current settings, select the "NEXT" button to change settings
• Select "NEXT"
• Enter the PIN when prompted.
• Select "NEXT"
• Verify that the PIN number is correct
• Once verified, select "NEXT"
• Select "NEXT"
Sep 30, 2010
K6860943 REV 1
4280274
Publicité
