HQ Power VDPC146 Mode D'emploi page 6

The red LED indicator above the RECORD key is now dimmed, meaning that the programming mode has been
deactivated and cannot be accessed.
6.2 Activating the Recording Mode
1. Hold the RECORD button.
2. Press the following flash keys in PRESET A: 1-5-6-8
3. Release the RECORD button.
The red LED indicator above the RECORD key is now lit, meaning that the programming mode has been
activated and can be accessed.
6.3 Erasing all Programmes
1. Hold the RECORD button.
2. Press the following flash keys in PRESET A: 1-3-2-3.
3. Release the RECORD button.
6.4 Clearing the Memory
1. Hold the RECORD button.
2. Press the REC CLEAR button.
3. Release both buttons.
6.5 Recording a Scene
1. Press MODE SELECT to select the 1-24 SINGLE / PRESET PARK function. The green LED indicator lights up.
2. Select the desired page with the PAGE button.
3. Slide both master faders to the top position (MASTER A = 10 & MASTER B = 0).
4. Place the 24 channel sliders in the desired position.
5. Press the RECORD button to store the scene in the memory.
6. Slide both master faders to the lowest position (MASTER A = 0 & MASTER B = 10).
7. Hold the record button.
8. Press the flash button of your choice (13-24).
9. Release the RECORD button.
The scene is now stored under one of the keys of n°7 in fig. 1 on page 2
6.6 Deleting a Scene
1. Select the desired page with the PAGE button.
2. Hold the RECORD button.
3. Press the flash button (13 – 24) where the scene was stored twice.
4. Release the RECORD button.
6.7 Recording a Chase
1. Press MODE SELECT to select 1-24 SINGLE / PRESET PARK. The green LED indicator lights up.
2. Select the desired page with the PAGE button.
3. Slide both master faders (MASTER A = 10 and MASTER B = 0) to the highest position.
4. Place the 24 channel sliders in the desired position.
5. Press RECORD to store the scene in the memory.
6. Place the 24 channel sliders in the desired position again.
7. Press RECORD to store this second scene in the memory.
8. Repeat the last two steps until a max. of 999 scenes have been programmed.
9. When you're done programming, slide both master faders (MASTER A = 0 and MASTER B = 10) to the
bottom.
10. Press the desired flash button (13 – 24).
11. Release the RECORD button.
The chase is now stored under one of the keys of n°7 in fig. 1 on page 2.
6.8 Deleting a Step from a Programme
1. Hold the EDIT button.
2. Press the desired flash button (13 – 24).
V. 02 – 21/10/2013
VDPC146
6 ©Velleman nv