Husqvarna 520iHE3 Manuel D'utilisation page 13

4. Hold the product near your body for a stable work
position.
5. Make sure that the tip of the cutting equipment does
not touch the ground.
6. Be careful and work slowly until all the branches are
correctly cut.
To adjust the angle of the product
The cutting deck can be adjusted in 8 different positions.
1. Remove the battery from the product.
2. Pull down the position adjustment handle.
3. Tilt the cutting deck with the handle to the applicable
position.
4. Release the position adjustment handle to lock the
cutting deck.
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the speed of the cutting
31 - 001 - 31.10.2018
equipment and gives the longest operation time from the
battery.
Note: The SavE function does not decrease the cutting
power of the product.
1. Push the SavE button on the keypad to start the
function. The green LED comes on.
2. Push the SavE button again to stop the function. The
green LED goes out.
Automatic shutdown function
The product has a shutdown function that stops the
product if it is not used. The green LED light for start/
stop indication will go out and the product shuts down
after 45 seconds.
To set the product in transport position
WARNING: Do not start the product when
the product is in transport position.
1. Remove the battery from the product.
2. Use the transport guard for transportation.
3. Tilt the cutting deck 180° in your direction.
To stop the product
1. Release the power trigger.
2. Push the start/stop button until the green LED goes
out.
13