Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
20
Problem
Air conditioner
does not start.
Air conditioner
does not cool as it
should.
Air conditioner
freezing up.
Water drips
outside.
Possible Cause
The air conditioner is unplugged.
The fuse is blown/circuit breaker
is tripped.
Power failure.
The current interrupter device is
tripped.
Airflow is restricted.
The temp control may not be set
correctly.
The air filter is dirty.
The room may have been hot.
Cold air is escaping.
Cooling coils have iced up.
The cooling coils are iced over.
Hot, humid weather.
Solutions
Make sure the air conditioner plug
is pushed completely into the outlet.
Check the house fuse/circuit
breaker box and replace the fuse or
reset the breaker.
If power failure occurs, turn the
mode control to off. When power is
restored, wait 3 minutes to restart
the air conditioner to prevent
tripping of the compressor overload.
Press the RESET button located
on the power cord plug. If the
RESET button will not stay
engaged, discontinue use of the air
conditioner and contact a qualified
service technician.
Make sure there are no curtains,
blinds, or furniture blocking the front
of the air conditioner.
Set the desired temperature to
a level lower than the current
temperature.
Clean the filter at least every 2
weeks. See the 'MAINTENANCE'
section.
When the air conditioner is first
turned on, you need to allow time
for the room to cool down.
Check for open furnace floor
registers and cold air returns.
See 'Air conditioner freezing up'
below.
Ice may block the air flow and
obstruct the air conditioner from
properly cooling the room. Set the
mode control at High Fan or High
Cool.
This is normal.
Publicité
