LG LW1016ER Manuel D'utilisation page 13

3
Loosely assemble each sill support.
NOTE
● If the distance to the outer window sill is
not that deep, you may not need the bolt
and nut.
4
Use 2 type A screws to attach a sill support
to the cabinet track holes on one side. Use
the cabinet track holes that will place the sill
support nearest to the outer edge of the sill.
Repeat with the second sill support on the
opposite side of the cabinet.
Outdoor
5
Install the cabinet with a slight tilt (about ½")
downward on the outside.
Use the bolt and nut to adjust the tilt of the
cabinet.
CAUTION
● Do not drill a hole in the bottom pan.
The product is designed to operate with
approximately ½" of water in the bottom
pan. There is no need to add water if the
pan is dry.
Sill Support
Nut
Bolt
Screws (Type A)
Indoor
about ½"
Cabinet
6
Attach the cabinet to the inside sill by
driving 3 type B screws through the cabinet
and into the sill.
Front Angle
NOTE
● Install the cabinet with a very slight
downward tilt toward the outside.
CAUTION
● Do not drill a hole in the bottom pan.
The product is designed to operate with
approximately ½" of water in the bottom
pan.
7
Pull each curtain panel out until it meets the
window sash track. Pull the bottom window
sash down behind the upper panel guide
until they meet.
Front Angle
NOTE
● Do not pull the window sash down so
tightly that the movement of the curtain
panels is restricted.
8
Use a screwdriver or power drill to attach
the curtain panels to the window sashes
by driving type C screws into the sashes
through the cabinet holes shown in the
INSTALLATION 13
Sash Track
Upper Panel
Guide
Sash Track
Inside Window Sill