LG LW1016ER Manuel D'utilisation page 15

OPERATION
Control Panel and Remote Control
7
4 3
Power
1
Operation starts when this buttom is pressed
and stops when you press the buttom again.
Fan Speed
2
Use to set the fan speed to Low (F1), MED
(F2), High (F3).
ON/OFF Timer
3
Delay ON - When the air conditioner is off,
it can be set to automatically turn on from
1 to 24 hours at its previous mode and fan
settings.
Delay OFF - When the air conditioner is on,
it can be set to automatically turn on from
1 to 24 hours.
NOTE
● Each press of the Timer button advances
the timer by 1 hour. After the last press
the display returns to the temperature
setting.
6
5
2 1
Remote Control
5
3
Operation Mode Selector
4
Push the Mode button to rotate between
Energy Saver / Cool / Fan / Dry.
Energy Saver - The fan stops when the
compressor stops cooling. Approximately
every 3 minutes the fan will turn on and
check the room air temperature if cooling
is needed.
Cool - Compressor runs and cools the
room. Use the
set the desired temperature and circulation
fan speed.
Fan - Fan circulates air but the compressor
does not run. Use the FAN button to set
the desired fan speed.
Dry - Dry mode is used to remove humidity
from the room without additional cooling.
Once the set temperature is reached, the
compressor and circulation fan turns off.
Fan speed is pre-set and cannot be
adjusted.
OPERATION 15
1
2
4
and FAN buttons to
.