Publicité
Les langues disponibles
Les langues disponibles
16
OPERATION
Temperature Control
5
The thermostat monitors room temperature
to maintain the desired temperature. The
thermostat can be set between 60 °F–86 °F
(16 °C–30 °C). Press
increase or decrease temperature setting.
Remote Control Sensor
6
Clean Filter
7
The Clean Filter LED lights up to notify you
that the filter needs to be cleaned. After
cleaning the filter, press Temp
together on the control panel to turn off the
Clean Filter light.
NOTE
● The filter reset must be done using the
control panel, not the remote control.
● This feature is a reminder to clean the air
filter for more efficient operation. The LED
light turns on after 250 hours of operation.
NOTE
● Auto Restart: If the air conditioner turns off due
to a power outage, it will restart automatically
once the power is restored, with the same
settings as were set before the unit turned off.
● Energy Saver: The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
● The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.
Wireless Remote Control
Inserting Battery
1
or
arrows to
and
2
3
NOTE
● Be sure that the (+) and (-) directions
are correct.
● Be sure that the battery is new.
● Do not use a rechargeable battery.
● In order to prevent discharge, remove the
battery from the remote control if the air
conditioner is not going to be used for an
extended period of time.
● Keep the remote control away from
extremely hot or humid places.
● To maintain optimal operation of the remote
control, the remote sensor should not be
exposed to direct sunlight.
Remove the cover from the back of the
remote controller.
Insert one battery.
Reattach the cover.
Publicité
