Salora 58UA220 Mode D'emploi page 82

Other Connections
If you want to connect a device to the TV, make sure that both the TV and the device are turned off before making
any connection. After the connection is done, you can turn on the units and use them.
Connector Type
Component
COMPONENT
Video
Connection
(back)
HDMI
Connection
(back&side)
VGA
Connection
(back)
VGA/
Component
AUDIO IN
Audio
Connection
(back)
SPDIF
SPDIF
(Optical Out)
Connection
(back)
Composite
COMPOSITE
(Audio/Video)
Connection
(back)
HEADPHONE
Headphone
Connection
(side)
USB
Connection
(side)
CI
Connection
(side)
LAN
Ethernet
Connection
(back)
Cables
VGA to Component Connection Cable
Audio Cable
Component/VGA
Audio Video Cable
LAN / Ethernet Cable
English - 6 -
To enable VGA/Component audio,
Device
you will need to use the back audio
inputs with a VGA/Component audio
cable for audio connection. When
using the wall mounting kit (contact
your dealer to purchase one, if not
supplied), we recommend that you
plug all your cables into the back of
the TV before mounting on the wall.
Insert or remove the CI module only
when the TV is SWITCHED OFF. You
should refer to the module instruction
manual for details of the settings. The
USB inputs on the TV support devices
up to 500mA. Connecting devices that
have current value above 500mA may
damage your TV. When connecting
equipment using a HDMI cable to your
TV, to guarantee sufficient immunity
against parasitic frequency radiation
and trouble-free transmission of high
definition signals, such as 4K content,
you have to use a high speed shielded
(high grade) HDMI cable with ferrites.