Hudora 72112/AM Instructions De Montage Et Mode D'emploi page 4

INSTRUCTIONS ON ASSEMBLY AND USE
EN
CONGRATULATIONS ON
PURCHASING THIS PRODUCT!
Please read these instructions carefully. The instructions are an integral component
of the product. Therefore, please store them and the packaging carefully in case
questions arise in the future. Please always include these instructions when handing
on the product to a third party. This product must be assembled by an adult. This
product is designed for private/domestic use only. This product is not designed for
commercial/industrial use. The use of the product requires certain capabilities and
skills. Always adjust according to the age of the user and use for the purpose it has
been designed for.
TECHNICAL SPECIFICATIONS
Item: Baby high swing
Item number: 72112/AM, 72174/00, 72174/AM
Max. Height for Suspension: 240 cm
Min. Height for Suspension: 160 cm
Max. Body Weight: 25 kg
Dimension: 36 x 35 cm
Purpose: Device for the supported swinging for toddlers.
Minimum user age: 12 months
If you have assembly problems or would like further information on the product, we
have all you need and more at http://www.hudora.de/.
CONTENTS
1 x Swing set
1 x These instructions
Other parts which may be included with the delivery in some circumstances are not
required.
SAFETY INSTRUCTION
• WARNING! Only for domestic use. Only suitable in the outdoors area.
• WARNING! Only use under direct supervision of an adult!
• WARNING! Not to be used by children over 36 months old, as not sufficiently
stable!
• The owners of the swing as well as the competent supervisory personnel are
responsible for ensuring that all users follow the instructions in the operation
manual.
• Do not make any technical modifications.
• Changes to the original product must only be carried out according to manufac-
turer specifications.
• No one is permitted to gain access to the swing area during use.
• Always hold on to the swing with both hands.
• No objects of any kind must be in the vicinity of the swing zone (trees, walls,
fences, clotheslines).
• Make sure that you have a safety clearance of at least 2 m (front and back) beyond
the maximum reach of the swing and make sure the ground is level and shock
absorbing (e.g. grass) without any sharp edges or pointed objects, obstacles, in-
clines, levels, steps or hard surfaces (e.g. concrete) etc.
• Clearance to stationary components on the side, such as the swing scaffolding,
must be at least 40 cm.
• Maximum raised height must not exceed 240 cm as measured from the ground.
• Swinging components, such as a neighboring swing, must be placed at a distance
of at least 60 cm.
• In idle mode, the swing must be at least 40 cm and maximally 60 cm from the
ground.
• You should never install a swing in such a way that the user could be blinded by
sun rays.
• Maximum deflection 60°:
WARNING! A much too forceful push of the swing seat beyond the recommended
maximum deflection (see fig. 1), can cause the seat to tilt and the child could as a
consequence fall out.
• Suspension connectors shall be of a design that will prevent unintentional discon-
nection.
• When permanently irradiated with UV light, the material ages significantly faster.
To avoid premature aging and thereby extend the service life, you should always
store the product in a dry and dark place when not in use. Do not permanently
expose the product to wind, moisture, extreme temperatures or sunlight.
All images are examples of the design.
ASSEMBLY
Prior to installation, carefully select and check the location where you will install the
swing. Please make sure that the swing carrier is adequately stable. Please also take
into account that swinging produces centrifugal forces that can put a lot of strain on
the swing carrier. Please consult an expert (statics expert, architect, carpenter) and
ask how much load your swing carrier can tolerate.
HANGING DEVICE AND ADJUSTMENT
The hanging points must be at least as far apart as the swing seat + 100 mm. The
swing is packaged with two ropes and adjustment eyelets, so that the height of the
swing can be variably aligned with any suitable hanging device. The length of the
swinging rope is respectively shortened or lengthened, by continuing to push the
double-layered rope through the length adjustment lugs (1) upwards or downwards
(fig. 2). The hanging swing can now be individually adjusted. No one should sit on the
swing while making the adjustments. When extending or reducing the length of the
swing ropes please make sure that the ropes remain equally long at all times. If the
lengths of the ropes differ, this will lead to circular pendulum movements of the
swing. Make sure that swing is set up in such a way that the person using the swing
cannot reach the ground with the tips of his or her toes. If in doubt, perform a few
gentle test swings.
SAFETY BAR WITH LOCKING FUNCTION
The swing is equipped with a lockable safety bar. To release the safety bar, first
press the click lock on the underside together and then upwards. The safety bar can
now be lifted. Before swinging, the safety bar must be firmly locked again. To do this,
press it back into the guide until you hear it click into place. Take care to avoid get-
ting pinched when locking the safety bar.
MAINTENANCE AND STORAGE
Check the product for damage or traces of wear and tear before and after each use.
We also recommend before each use:
• to check for the firm sitting of nuts and bolts, tighten if necessary
• to lubricate moving parts in order to minimize wear
• to check all covers of screws and sharp edges and replace if necessary
• to replace defective parts according to the manufacturer's instructions
• to check swing seats, chains, ropes and other means of attachments for evidence
of deterioration
You should also replace all the plastic parts after a maximum of 5 years to prevent a
possible failure of these parts.
Use a dry or damp cloth only to clean the product; do not use special cleaning agents!
Store the product in a safe place where it is protected from the elements, cannot be
damaged, and cannot injure anyone. If parts become damaged or if sharp edges or
corners should develop, the product may not be used any more. If in any doubt,
please contact our service team (http://www.hudora.de/). Store the product in a safe
place where it is protected from the elements, cannot be damaged, and cannot injure
anyone.
DISPOSAL ADVICE
At the end of the product's life, please dispose of it at an appropriate collection point
in your area. Local waste management companies will be able to answer your que-
stions on this.
SERVICE
We make every effort to deliver faultless products. If faults do arise however, we put
just as much effort into rectifying them. Therefore, you can find numerous informa-
tion on the product, replacement parts, solutions to problems and lost assembly
manuals at http://www.hudora.de/.
4/8