Rockford Fosgate T5002 Manuel D'installation Et De Fonctionnement page 5

7. Remote Bass – The Para-Punch Remote Bass connection is made with a RJ-45 cable and can be installed
in a variety of ways for easy control access. One control is used to boost low frequency information to
overcome road noise and put the bass in your face.This Bass control is a narrow band adjustment
variable from 0dB to +18dB with a Gyrator based Punch EQ that eliminates frequency shift with boost.
The other control is used for adjusting center frequency variable from 35Hz to 70Hz.
8. Infrasonic Filter – A 28Hz High Pass filter designed to prevent frequencies below the audio range
from being applied to the subwoofer from the amplifier. Consequently improving subwoofer
performance and power handling, particularly in vented enclosures.
9. Gain Control – The input gain control is preset to match the output of most source units. It can be
adjusted to match output levels from a variety of source units.
10. Variable Crossover – Is a built-in adjustable filter selectable for High-Pass (HP), All Pass (AP), or
Low-Pass (LP) operation variable from 40Hz to 400Hz in x1 mode, and 400-4000Hz in x10 mode.
11. Frequency Multiply Switch – Used to set the multiplier for the crossover frequencies between x1
and x10. A setting of x1 leaves the adjustable crossover frequency from 40-400Hz. A setting of x10
changes the adjustable crossover frequency to 400-4000Hz
12. Slope Switch – Used to select between a 12dB/octave Butterworth or 24dB/octave Linkwitz-Riley
filter.
13. RCA Input Jacks – The industry standard RCA jacks provide an easy connection for signal level input.
They are nickel-plated to resist the signal degradation caused by corrosion.
14. RCA Active Pass-Thru Jacks – This Active Pass-Thru provides a convenient source for daisy-chaining
an additional amplifier without running an extra set of RCA cables from the front of the vehicle to the
rear amplifier location.
15. Preamp Output Crossover – Is used to set the crossover output for the Pass-Thru Jacks
selectable for High-Pass (HP), All Pass (AP), or Low-Pass (LP) operation. If set to HP or LP the
frequency of th Pass-Thru outputs will be the same frequency selected for the main crossover.
16. Remote Terminal – This heavy duty, platinum-plated wire connector will accept wire sizes from
12 AWG to 24 AWG.This terminal is used to remotely turn-on and turn-off the amplifier when
+12V DC is applied.
17. Power Terminals – The power and ground connectors on the amplifier are platinum-plated and will
accommodate up to 1/0 AWG wire maximizing the input current capability of the amplifier.
INSTALLATION CONSIDERATIONS
The following is a list of tools needed for installation:
Volt/Ohm Meter
Wire strippers
Wire crimpers
Wire cutters
#2 Phillips screwdriver
Battery post wrench
Hand held drill w/assorted bits
1/8" diameter heatshrink tubing
Assorted connectors
Adequate Length—Red Power Wire
Adequate Length—Remote Turn-on Wire
Adequate Length—Black Grounding Wire
D F
ESIGN EATURES
I
NSTALLATION
5