MSI K9A2GM V2 Serie Manuel D'instructions page 10

All manuals and user guides at all-guides.com
REAR PANEL
The rear panel provides the following connectors:
Mouse
Keyboard Serial Port
HARDWARE SETUP
This chapter tells you how to install the CPU, memory modules, and expansion cards, as
well as how to setup the jumpers on the mainboard. It also provides the instructions on
connecting the peripheral devices, such as the mouse, keyboard, etc. While doing the
installation, be careful in holding the components and follow the installation procedures.
CPU Installation Procedures for Socket AM2
1. Please turn off the power and unplug the power
cord before installing the CPU.
2. Pull the lever sideways away from the socket.
Make sure to raise the lever up to a 90-degree
angle.
3. Look for the gold arrow of the CPU. The gold
arrow should point as shown in the picture. The
CPU can only fit in the correct orientation.
4. If the CPU is correctly installed, the pins should be
completely embedded into the socket and can not
be seen. Please note that any violation of the
correct installation procedures may cause
permanent damages to your mainboard.
5. Press the CPU down firmly into the socket and
close the lever. As the CPU is likely to move while
the lever is being closed, always close the lever
with your fingers pressing tightly on top of the
CPU to make sure the CPU is properly and
completely embedded into the socket.
Important:
Overheating will seriously damage the CPU and system. Always make sure the cooling fan
can work properly to protect the CPU from overheating.
Parallel Port
VGA Port
1394 Port
LAN
(optional)
USB Ports
Sliding
the plate
Gold arrow
Press down
the CPU
4
Line-In RS-Out
Line-Out CS-Out
MIC SS-Out
Open the lever
90 degree
Correct CPU
placement
O
Close
the lever