Klarstein FULL HOUSE 3.0 Mode D'emploi page 58

EN
58
• Do not use adapters, reducers or branches in combination with the appliance as
this could lead to overheating and fire hazard.
• Make sure that the cable does not come into contact with the hot parts of the
appliance. The mains cable must be laid in such a way that its temperature does not
exceed 75 °C at any time.
Note: If you are unsure whether the wiring in your home is suitable for the appliance,
consult your electrician. Any modifications may only be carried out by a qualified
electrician.
The power supply must comply with national standards. The connection method is shown
below:
Electrical Safety Instructions
• If the power cord is damaged or needs to be replaced, contact the manufacturer,
customer service or a similarly qualified person to avoid a hazard.
• If the unit is connected directly to the socket, a multi-pole circuit breaker with a
minimum distance of 3 mm between the contacts must be installed.
• The national regulations must be observed during installation.
• The mains cable must not be kinked or bent.
• The mains cable must be checked regularly for damage by persons qualified to do
so.
• The yellow/green wire must be connected to the ground wire and terminals of the
device.
• The manufacturer is not liable for damage caused by missing or improperly
performed grounding.
• The socket used for the appliance must be easily accessible at all times.