Sony VPL-PX40 Mode D'emploi page 43

Remote Commander
Symptom
The Remote Commander
does not work.
The menu display does not
appear even when you
press the MENU key on the
Remote Commander.
Others
Symptom
The LAMP/COVER
indicator flashes.
The LAMP/COVER
indicator lights up.
The TEMP/FAN indicator
flashes.
The TEMP/FAN indicator
lights up.
Both the LAMP/COVER
and TEMP/FAN indicators
light up.
Warning Messages
Use the list below to check the meaning of the messages displayed on the screen.
M essage
High temp.!
Lamp off in 1 min.
Frequency is out of range!
Please check INPUT-D
setting.
Please replace the LAMP.
Downloaded from:
Cause and Remedy
• The Remote Commander batteries are dead.
c Replace with a new battery (see page 16).
• The PJ/NETWORK select switch on the Remote Commander is
set to NETWORK.
c Set the PJ/NETWORK select switch to PJ, then press the
MENU key.
Cause and Remedy
• The lamp cover or the air filter cover is detached.
c Attach the cover securely (see page 38).
• The lamp has reached the end of its life.
c Replace the lamp (see page 38).
• The lamp becomes a high temperature.
c Wait for 90 seconds to cool down the lamp and turn on the
power again (see page 28).
• The fan is broken.
c Consult with qualified Sony personnel.
• The internal temperature is unusually high.
c Check to see if nothing is blocking the ventilation holes.
• The electrical system breaks down.
c Consult with qualified Sony personnel.
Meaning and Remedy
• Internal temperature is too high.
c Turn off the power.
c Check to see if nothing is blocking the ventilation holes.
• This input signal cannot be projected as the frequency is out of the
acceptable range of the projector.
c Input a signal that is within the range of the frequency.
• The resolution setting of the output signal of a computer is too
high.
c Set the setting of output to XGA (see page 18).
• You have input RGB signal from the computer when Input-D
Signal Sel. in the SET SETTING menu is set to Component.
c Set Input-D Signal Sel. correctly (see page 35).
• It is time to replace the lamp.
c Replace the lamp.
https://www.usersmanualguide.com/
43
Troubleshooting
GB