Mounting - Gossen MetraWatt KINAX WT 710 Mode D'emploi

6. Mounting

The relationship between the types of mounting, or more precisely the corresponding cut-out diagrams and the different
versions of the transmitter can be seen from Table 2.
Table 2:
Transmitter Drilling and cut-out diagrams
versions for mounting transmitters ...
Three M3 screws are needed for the "directly" mounted
versions and two M6 nuts and bolts for those "with a
bracket". The screws, respectively nuts and bolts are not
supplied, because the required length varies according to
the thickness of the mounting surface.
When deciding where to install the transmitter
(measuring location), take care that the ambient
conditions given in Section 5 "Technical data" are
not exceeded.
3.2
5
M3
M4
Transmitter Drilling and cut-out diagrams
versions for mounting transmitters ...
Make the cut-out or drill the holes in the item onto which the
transmitter is to be mounted according to the corresponding
drilling and cut-out diagram given in Table 2 and then fit the
transmitter.
When installing or servicing intrinsically safe (Ex)
instruments, care must be taken to avoid electro-
static charges.
The transmitter may only be use for detecting a
turning angle and not to permanently measure
speed.
Ø6.8
±0.2
80
95
80
44-H8
25
M4
±0.05
53
23