Brief Description; Scope Of Supply - Gossen MetraWatt KINAX WT 710 Mode D'emploi

Operating Instructions
Transmitter for angular position KINAX WT 710
Contents
1. Read first and then... ................................................ 20
2. Brief description ........................................................ 20
3. Scope of supply ........................................................ 20
4. Specification and ordering information ..................... 21
5. Technical data ........................................................... 21
6. Mounting ................................................................... 23
7. Electrical connections ............................................... 24
8. Setting the beginning and end
of the measuring range ............................................. 25
9. Adaptation from 2-wire connection to
3 or 4-wire connection and vice versa ...................... 26
10. Reversing the rotation
for instruments with measuring ranges > 150
11. Dimensional drawings ............................................... 26
1. Read first and then ...
The proper and safe operation of the device
assumes that the Operating Instructions are
read carefully and the safety warnings given
in the various Sections
6. Mounting
7. Electrical connections
8. Setting the beginning and end
of the measuring range
10. Reversing the rotation for
instruments with measuring
ranges > 150
are observed.
The device should only be handled by
appropriately trained personnel who are
familiar with it and authorised to work in
electrical installations.

2. Brief description

The KINAX WT 710 converts the angular position of a shaft
into a load-independent direct current signal, proportional
to the angular position.
Explosion-proof "Intrinsically safe" versions with I.S.
measuring output rounds off this series of transmitters.
20

3. Scope of supply

Transmitter (Fig.1)
3 clamps (Fig. 4)
1 protection cap
1 operating instructions (Fig. 5), in three languages: German,
French, English
1 Ex approval (Fig. 5), for instruments in Ex version only
Fig. 1
° ..... 26
Transmitter for fitting on measuring instruments with
revolving indicator shaft (Fig. 2)
1 mounting ring
1 sealing ring
1 driving fork for 1.5 mm dia. on measuring instrument
1 coupling lever for 2 mm dia. on angle transmitter
3 clamps (Fig. 4)
3 screws M4 × 8
1 protection cap
1 operating instructions (Fig. 5), in three languages: German,
French, English
1 Ex approval (Fig. 5), for instruments in Ex version only
Fig. 2
Transmitter with additional gear (Fig. 3)
3 clamps (Fig. 4)
1 mounting foot
2 screws M5 × 10
°
2 spring washer
1 operating instructions (Fig. 5), in three languages, German,
French, English
1 Ex approval (Fig. 5), for instruments in Ex version only
Fig. 3
Fig. 4
Betriebsanleitung
Messumformer für Drehwinkel KINAX WT 710
Mode d'emploi
convertisseur de mesure
pour angle de rotation KINAX WT 710
Operating manual
Transmitter for angular position KINAX WT 710
WT 710 B d-f-e 139 429 12.99
Aargauerstrasse 7
CH-5610 Wohlen/Switzerland
Telefon +41 57 21 21 11
Telefax +41 57 22 74 32
Camille Bauer AG Telex 827 901 cbm ch
Fig. 5