Publicité
Les langues disponibles
Les langues disponibles
BM 2610958575 02-09:BM 2610958575 02-09 2/4/09 10:55 AM Page 8
NOTE: Do not wash the micro filter with soap
and water. Dust may become more firmly
lodged in the pores, which will reduce dust
collection, and damage the micro filter.
DUST ExTRACTION
Your tool is equipped with a dust port for dust
extraction. To use this feature, insert
standard 1-1/4" vacuum hose into the dust
port, and connect the opposite end of the
hose to a shop vacuum cleaner (Fig. 2).
Note: When using vacuum dust extraction
with this tool, use an anti-static vacuum hose
to reduce the likelihood of a static discharge
if the vacuum hose contacts your body while
sanding.
Aluminum oxide, silicon carbide, or other
synthetic abrasives are recommended for
power sanding use. Natural abrasives, such as
flint or garnet sheet are too soft for economical
use in power sanding. The uniform spacing
between grains minimizes filling or loading. The
high quality aluminum oxide sheet with heavy
backing, cuts faster and lasts longer.
Some applications, such as plastics, glass, or
stone require silicon carbide discs, which have
a very sharp cutting edge.
For best results, use sanding accessories
which are of superior quality and are carefully
selected to produce professional quality results
with your sander.
The following are recommended abrasive
sheets and applications:
1. Coarse Grit:
For rough wood sanding.
All manuals and user guides at all-guides.com
Sanding Tips
-8-
2. Medium Grit:
For general wood sanding.
3. Fine Grit:
For smoothing wood or
plaster patches.
4. Extra Fine Grit: For final sanding bare
wood and smoothing old
paint.
If the surface is rough, begin with coarser grits
and then complete the surfacing with medium
and fine abrasives. Because the random orbit
action is so effective, it is often possible to
begin sanding with a medium grit disc and go
directly to fine finishing. To avoid uneven
results, do not skip more than one grit size
when going from coarser to finer, and do not
sand in one area for too long. When the job is
completed, release switch, and gently lift the
tool from the work surface at the same time.
FIG. 2
ST ND RD 1-1/4"
V CUUM HOSE
DUST PORT
Publicité
