Char-Broil RED 466250509 Instructions D'installation page 21

12
First, remove the two screws and lock washers factory attached to the sideburner valve bracket.
Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger
center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using screws
and lock washers that were removed from bracket, shown A.
Place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia.
Attach sideburner bezel to fascia using two
Press sideburner control knob onto valve stem, shown
A
Screws and washers
removed from
valve bracket
Valve bracket
B
Note: Make sure set the Bezel with
longer slot at the top.
Control Knob
#8-32x3/8"
screw
4mm Lock
washer
Sideburner Bezel
screws and 4mm lock washers.
#8-32x3/8"
B.
Sideburner shelf
Note: Use left and right holes
on fascia to attach valve bracket
Sideburner shelf Fascia
Note: Use upper and lower holes
on fascia to attach bezel
valve stem
21