Char-Broil RED 466250509 Instructions D'installation page 17

7
Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and
facing the front. Secure using two 1/4-20x1½" screws, 7mm lock washers, and 7mm flat washers on each side.
NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN
ASSEMBLED TO CART.
8
On back of grill, place upper back panel between side panels and
above lower back panel. Secure upper back panel, in lower holes,
using one 1/4-20x1½" screw, 7mm lock washer, and 7mm flat
washer on each side. Do not fully tighten screws until side shelf
installation is complete in later steps.
Front brace
Door
Hinge Pin
7mm flat
washer
1/4-20x1½"
screw
Upper back panel
1/4-20x1½"
7mm lock
washer
screw
Note: some parts omitted
for clarity of illustration
7mm flat
7mm lock
washer
washer
17