Aiwa CSD-MP100 Mode D'emploi page 9

Programmed play
You can arrange the playing order of up to 20 tracks
and/or albums on a CD.
1
Select CD function and place the CD.
2
In stop mode, press PROGRAM.
"PROGRAM" flashes in the display.
(CD-DA)
3
Press r or t to select a track.
(CD-DA)
When selecting the track in the album, use ALBUM
SKIP + or - as well.
Tip (MP3)
You can program all of the tracks in the specific
album as one program. Press ALBUM SKIP + or -
to select the album number only. "001 (album
number) -ALL", for example, will be displayed.
4
Press PROGRAM to store it.
(CD-DA)
Total number of the
selected tracks
Pressing the number buttons on the remote selects
and stores the specific track at the same time.
5
Repeat steps 3 and 4 to program other
tracks.
(MP3)
(MP3)
(MP3)
Total playing time of
the selected tracks
6
Press s to finish the program.
"PROGRAM" stops flashing.
Pressing E finishes the program and starts
programmed play.
Tip
You can repeat the programmed play.
After programming, press REPEAT to display "[".
To check the program
1 Press r or t to display the program number.
2 While the program number is displayed, press
DISPLAY.
The programmed track number and its playing time
(or programmed album and track number) is
displayed.
3 Repeat steps 1 and 2 to check all the program.
To clear the program
Hold down PROGRAM until "PROGRAM" disappears.
The program is also cleared when the CD compartment
is opened or the function is changed.
To add other tracks to the program
Follow the steps 2 to 6 above. The new tracks are
added after the last programmed track.
You cannot program more than 20 tracks and/or
albums. "P-FULL" will be displayed.
To change the program
Clear the program and repeat all the steps again.
Notes
• The total playing time of the selected tracks will be
displayed as "—:—":
- When it exceeds "99:59".
- When a track number 100 or higher is selected.
• In programmed playback mode, resume function
does not work and locating the specific track with the
number buttons is not available.
9
ENGLISH