Thermador Professional PG304 Instructions D'installation page 9

GAS AND ELECTRIC SUPPLY ZONES:
FIG. 3A Gas & Electrical Supply Zones for All Gas Ranges
Typical placement shown.
Other placement of
Electrical Supply and
Receptacle within the
Electrical and Gas Supply
Zone is acceptable.
NOTE:
A Manual Gas
Shut-Off Valve
(not shown)
must be easily
Protrusion from Wall
accessible
through an
adjacent cabinet
without moving
the range.
Model
PG30
PG36
PG48
NOTE: Any opening in the wall behind the appliance and
any opening in the floor under the appliance must be
sealed.
IMPORTANT:
The cord supplied with gas ranges having electric griddle
(PG364GE, PG486GE, and PG484GGE) requires a NEMA 5-20
receptacle, shown here. Local codes may require a different
wiring method.
Step 2: Cabinet Preparation
3/4" Flex Line to
Appliance
Gas
1/2"
Supply
N.P.T.
Zone
2" Maximum
for Gas Supply
Floor
A B C
8" 12" 10"
10-1/2" 15" 10-1/2"
16-1/2" 16" 15-1/2"
The All Gas ranges may be con-
nected to the power supply with a
range supply cord (supplied with
range) or by hard-wiring to the
power supply. It is the responsibil-
ity of the installer to provide the
proper wiring components (cord
or conduit and wires) and com-
120 VAC Receptacle
(Shown) or Junction
plete the gas connection as dic-
Box
tated by local codes and ordi-
Centerline of
Electrical
nances, and/or the National Elec-
Supply Zone
tric Code. The units must be prop-
erly grounded. Refer to Step 6 for
details.
D
E
The range must be connected
only to the type of gas for which
it is certified. If the range is to be
connected to propane gas, ensure
D E
that the propane gas supply tank is
6-1/2" 5-1/4"
equipped with its own high pressure
6-1/2" 5-1/4"
regulator in addition to the pressure
6-1/2" 5-1/4"
regulator supplied with the range.
(See STEP 5.)
7
PLUG
NEMA 5-20
RECEPTACLE