Publicité
Les langues disponibles
Les langues disponibles
DUE TO THE SIZE AND WEIGHT OF THIS RANGEHOOD, THREE PEOPLE ARE REQUIRED TO INSTALL THE CANOPY.
Two people must hold the canopy in place while the third person installs the screws that attach the canopy to the chimney.
The manufacturer assumes no responsibility for injury or damage caused by improper installations.
4. From below, attach the CANOPY SECTION (A in FIGURE
11) to the assembled chimney support using the four bolts
provided (F in FIGURE 11).
MAKE THE INTERNAL ELECTRICAL CONNECTIONS
5. Connect the CONTROL CABLES together as indicated in
A in FIGURE 12. Connect the LIGHT CABLES together as
indicated in B in FIGURE 12. Insert the connected CONTROL
CABLES (A in FIGURE 12) into the black plastic CONNECTOR
BOX (C in FIGURE 12) by connecting the two black plastic
pieces using the four screws provided. Using the two longer
screws provided, attach the assembled CONNECTOR BOX to
the METAL FLANGE (D in FIGURE 12).
B
A
D
FIGURE 12
WARNING
!
FIGURE 11
A
C
B
For ductless installations, install the CHARCOAL FILTER (F in
FIGURE 9) behind the center grease filter opening by inserting
and locking into place.
FIGURE 13
6. Install the grease filters using two hands by first pulling and
turning the knob to the left so that the locking lever does not
protrude from the filter (as in FIGURE 14). Insert the opposite
end of the filter into the retaining channel. Insert the knob end
next, then turn knob to the right to lock the filter into place.
FIGURE 14
7. Turn the power supply on. Turn on blower and lights. If the
rangehood does not operate, check that the circuit breaker
is not tripped or the house fuse blown. If the unit still does
not operate, disconnect the power supply and check that the
wiring connections have been made properly.
Version 08/06 - Page 8
Publicité
