Publicité
INSTALLING HOLD DOWN BRACKETS
Hold down brackets are provided as standard equipment with marine models or may be purchased separately to secure your
RV SaniPottie
portable toilet in the desired location. The following instructions are provided as a guideline for your convenience.
®
1. Position SaniPottie
adequate clearance for lid and seat in up position and clearance at the
sides to unlatch and remove top tank.
2. Open side clasps by pulling outward at top of side clasps.
3. Place hold down brackets, with mounting holes facing away from toilet,
under the tank and align with grooves. See Figure 1.
4. Use pencil or awl to mark location of hold down bracket mounting holes.
5. Remove SaniPottie
6. Attach hold down brackets to the floor or deck with screws provided.
7. Set SaniPottie
®
"MSD" PERMANENT INSTALLATION
Portable toilets are legally acceptable for use in vessels not having permanently installed toilets, as determined by the United
States Coast Guard. However, some states and the Canadian province of Ontario require a permanently installed portable
toilet, such as the 964MSD and 965MSD.
INSTALLATION POSSIBILITIES
SaniPottie
964MSD/965MSD Rear View
®
1-1/2" Deck Waste Fitting
2" Hose Clamp
5/8" Vent
3/4" Hose Clamp
Hose
5/8" Thru-hull Vent Fitting
(installed above water line)
3/4" Hose Clamp
5/8" Vent Fitting
(included with SaniPottie)
All manuals and user guides at all-guides.com
®
portable toilet in desired location. Make sure of
®
portable toilet.
portable toilet between brackets and latch in place with side clasps.
SeaLand No. 342871
OdorSafe Sanitation
Hose
1-1/2" Swivel Nut
(included with SaniPottie)
1-1/2" Hose Adapter
(included with SaniPottie)
1-1/2" Gasket
(included with SaniPottie)
Direct Overboard Discharge
SaniPottie
Remove Cap From Bottom
Tank Vent Adapter
Dockside Pumpout
To Remote Holding Tank
7
Figure 1
964MSD/965MSD
®
Remove 1-1/2" Cap & Plug
From Bottom Tank Waste
Discharge Adapter
Fresh Water Tank
Holding Tank
Publicité
