Dolmar EB166 Manuel D'instructions Original page 9

OPERATING TIPS (Fig. 7)
• Assure the unit is not directed at anybody or any loose
debris before starting the unit.
• Verify that the unit is in good working condition. Make
sure the tubes and guards are in place and secure.
• Always hold the unit with both hands when operating.
• Keep a firm grip on both the front and rear handle or
grips.
• To reduce the risk of hearing loss associated with sound
level(s), hearing protection is required.
• Use the shoulder strap when using unit as a mulcher.
• Be sure the bag is installed properly and zipped closed
(when used as a mulcher).
• Operate power equipment only at reasonable hours
- not early in the morning or late at night when people
might be disturbed. Comply with times listed in local
ordinances. Usual recommendations are 9:00 am to
5:00 pm, Monday through Saturday.
• To reduce noise levels, limit the number of pieces of
equipment used at any one time.
• To reduce noise levels, operate the tool at low speed
if possible.
• Use rakes and brooms to loosen debris before
blowing.
• In dusty conditions, slightly dampen surfaces.
• Conserve water by using power blowers instead of
hoses for many lawn and garden applications, including
areas such as gutters, screens, patios, grills, porches,
and gardens.
• Watch out for children, pets, open windows or freshly
washed cars, and blow debris safely away.
• Clean up after using blowers and other equipment.
Dispose of debris appropriately.
NOTE:
• Please ensure that the Mulching Gate is completely
closed and locked.
AIR VENTS
• Never cover air vents. Keep them free from obstructions
and debris. They must always remain clear for proper
motor cooling.
WARNING:
• To avoid serious personal injury, do not wear loose
fitting clothing or articles such as scarves, strings,
chains, ties, etc., that could get drawn into the air vents.
To make sure long hair does not get drawn into the air
vents, tie back long hair.
OPERATING AS A BLOWER
Hold the blower firmly. Sweep from side to side with the
nozzle several inches above the ground or floor. Slowly
advance the unit, keeping the accumulated pile of debris
in front of you. Most dry blowing operations are better
suited to low speeds, rather than high. High speed blow-
ing is a better way to move heavier items like large debris
or gravel.
OPERATING AS A MULCHER (optional
accessory)
Hold the tool firmly, tilting the mulcher tubes (5–10 cm),
and use a sweeping action to collect light debris. The
debris will flow into the bag. Items such as small leaves
and twigs will be mulched as they pass through the fan
housing. For longer bag life and increased performance,
empty the bag often.
CLEARING A BLOCKED TUBE / IMPELLER
WARNING:
• To avoid serious personal injury, be sure the unit is OFF
and unplugged before clearing the impeller.
WARNING:
• To avoid serious personal injury, always wear gloves to
protect yourself from the impeller blades or other sharp
objects.
• Slide the Power/Speed slide switch to the OFF position,
and wait until the unit comes to a complete stop.
• Unplug the unit.
• Remove the blower tube or mulcher tubes and the
bag.
• Carefully remove material blocking the tube or impeller.
Inspect the blades to ensure no damage has occurred.
Rotate the impeller blades by hand to ensure the block-
age is completely cleared.
• Reinstall the blower tube or mulcher tubes and the
bag.
• Plug the unit back into the power supply.
MAINTENANCE
WARNING:
• Never use water for cleaning your product, use only a
dry cloth. Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks may
result.
• Switch off and disconnect from the mains power supply
before cleaning or checking your product.
• Always empty the collection bag.
• Always store the product in a dry place ensuring the
cable is not likely to be damaged.
CLEANING THE COLLECTION BAG
• Empty the collection bag after each use to avoid dete-
rioration and obstruction of the air flow which will reduce
the performance of the unit.
• Clean the collection bag as needed. With eye protection
on, turn the dust bag inside out after initial emptying and
vigorously shake out the dust and debris.
DISPOSAL
Waste electrical products should not
be disposed of together with household
waste. Please recycle where facilities
exist. Check with your local authority or
retailer for recycling advice.
MAINTENANCE AND STORAGE INFORMATION
Prior to cleaning or any maintenance, always ensure the
power plug has been removed from the electric power
supply. When you have finished using the tool, always
check to make sure the product is clean and free of dirt
and debris.
• Do not use solvents to clean the tool.
• Store the tool in a dry place, and out of reach of
children.
POWER CORD MAINTENANCE
If the supply cord needs replacing, the task must be car-
ried out by an authorised service centre in order to avoid
a safety hazard.
If the supply cord is damaged, it must be replaced by
Dolmar service center in order to avoid a hazard.
9