Dolmar EB166 Manuel D'instructions Original page 10

TROUBLE SHOOTING
PROBLEM
Unit will not blow or
mulch.
Unit will not start.
EC DECLARATION OF CONFORMITY
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
10
POSSIBLE CAUSE
1. Bag full
2. Blocked tube
3. Blocked impeller
4. Dirty bag
5. Torn bag
6. Bag unzipped
7. Unit unplugged
1. Unit is unplugged.
2. Power/speed slide switch is in
the OFF position.
3. Mulcher tubes and bag, are not
correctly installed.
4. Intake gate/cover is not closed.
5. House circuit may have tripped.
SOLUTION
1. Empty the bag.
2. Clear the blockage.
3. Clear the blockage.
4. Clean the bag.
5. Replace the bag.
6. Zip up the bag.
7. Plug into an outlet or an extension cord.
1. Check cord to make sure it is plugged into an
electrical outlet.
2. Slide switch to high or low.
3. Check the mulcher tubes and bag to ensure
that they are allowing the switch to be
engaged when correctly installed.
4. Ensure that gate/cover is fully closed and
locked.
5. Check wall circuit breaker panel and reset if
necessary.