Stihl BGE 61 Notice D'emploi page 10

English
Mounting the Nozzle
6
Push the nozzle (5) onto the blower
N
tube (1) as far as lug (6),
position (a) (long) or position (b)
(short), and rotate the nozzle in the
direction of the arrow to it lock in
position.
Removing the Blower Tube
4
Switch off the motor.
N
Press down the lock button by
N
inserting a suitable tool through the
opening in the union nut.
Rotate the union nut (4) in the
N
direction of arrow as far as the stop.
Remove the blower tube (1).
N
8
Assembling the Vacuum
Attachment
BGE 71 only
Your vacuum shredder can be switched
on only when the elbow and suction tube
are properly mounted. The union nuts
activate a switch which closes the circuit
a b
to allow the motor to be switched on.
Disconnect the plug from the power
N
supply.
Mounting the Elbow
WARNING
Make sure the zipper on the catcher bag
is closed.
1
1
Push the elbow (1) into the catcher
N
bag (2) as far as the mark (smaller
arrow).
Tighten strap (3) on catcher bag
N
and press down the buckle tab (4).
Line up the recesses.
N
Push the elbow (5) into the blower
N
housing stub (6) as far as stop.
Push the union nut (7) over the
N
blower housing stub (6) and turn it in
the direction of the arrow as far as
the stop. You will hear the safety
switch being activated.
Assembling the Suction Tube
3
2
4
Line up the arrows on the suction
N
tube and extension tube. Push
together and lock in position.
7
5
6
BGE 61, BGE 71