Télécharger Imprimer la page

Black & Decker KG750 Mode D'emploi page 12

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Place the disc (11) onto the spindle (5) as
shown (fig. B). If the disc has a raised centre
(12), make sure that the raised centre faces
the inner flange.
Make sure that the disc locates correctly on
the inner flange.
Place the outer flange (13) onto the spindle.
When fitting a grinding disc, the raised centre
on the outer flange must face towards the
disc (A in fig. C). When fitting a cutting disc,
the raised centre on the outer flange must
face away from the disc (B in fig. C).
Keep the spindle lock (3) depressed and
tighten the outer flange using the two-pin
spanner (14) (fig. D).
Removing
Keep the spindle lock (3) depressed and
loosen the outer flange (13) using the
two-pin spanner (14) (fig. D).
Remove the outer flange (13) and the disc
(11).
Fitting and removing sanding
discs (fig. D & E)
For sanding, a backing pad is required. The
backing pad is available from your Black &
Decker dealer as an accessory.
Fitting
Place the inner flange (10) onto the spindle
(5) as shown (fig. E). Make sure that the
flange is correctly located on the flat sides of
the spindle.
Place the backing pad (15) onto the spindle.
Place the sanding disc (16) onto the backing
pad.
Place the outer flange (13) onto the spindle
with the raised centre facing away from the
disc.
12
All manuals and user guides at all-guides.com
Removing
Use
Warning! Let the tool work at its own pace. Do
not overload.
Switching on and off
Warning! Do not switch the tool off while under
load.
Hints for optimum use
Keep the spindle lock (3) depressed and
tighten the outer flange using the two-pin
spanner (14) (fig. D). Make sure that the outer
flange is fitted correctly and that the disc is
clamped tightly.
Keep the spindle lock (3) depressed and
loosen the outer flange (13) using the two-pin
spanner (14) (fig. D).
Remove the outer flange (13), the sanding
disc (16) and the backing pad (15).
Carefully guide the cable in order to avoid
accidentally cutting it.
Be prepared for a stream of sparks when the
grinding or cutting disc touches the
workpiece.
Always position the tool in such a way that
the guard provides optimum protection from
the grinding or cutting disc.
To switch on, slide the on/off switch (1)
forward. Note that the tool will continue
running when you release the switch.
To switch off, press the rear part of the on/off
switch.
Firmly hold the tool with one hand around the
side handle and the other hand around the
main handle.
When grinding, always maintain an angle of
approx. 15° between the disc and the
workpiece surface.

Publicité

loading

Ce manuel est également adapté pour:

Kg751