Black & Decker KG750 Mode D'emploi page 11

Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury,
the user must read the instruction
manual.
Wear safety glasses or goggles when
operating this tool.
Wear ear protection when operating
this tool.
Electrical safety
This tool is double insulated; therefore
no earth wire is required. Always check
that the power supply corresponds to
the voltage on the rating plate.
•
If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black & Decker Service Centre in
order to avoid a hazard.
Features
This tool includes some or all of the following
features.
1. On/off switch
2. Side handle
3. Spindle lock
4. Guard
Assembly
Warning! Before assembly, make sure that the
tool is switched off and unplugged.
Fitting and removing the guard
(fig. A)
The tool is supplied with a guard intended for
grinding purposes only. If the unit is intended to
perform cutting off operations, a guard specific
for this operation must be fitted. A suitable guard
for cutting off operations part numbers
1004484-06 for KG750 and 1004484-07 for
All manuals and user guides at all-guides.com
KG751 are available and can be obtained from
Black & Decker service centres.
Fitting
•
•
•
•
•
•
Removing
•
•
•
Warning! Never use the tool without the guard.
Fitting the side handle
•
Warning! Always use the side handle.
Fitting and removing grinding or
cutting discs (fig. B - D)
Always use the correct type of disc for your
application. Always use discs with the correct
diameter and bore size (see technical data).
Fitting
•
•
Place the tool on a table, with the spindle (5)
facing up.
Release the clamping lock (7) and hold the
guard (4) over the tool as shown.
Align the lugs (8) with the notches (9).
Press the guard down and rotate it
counterclockwise to the required position.
Fasten the clamping lock (7) to secure the
guard to the tool.
If required, tighten the screw (6) to increase
the clamping force.
Release the clamping lock (7).
Rotate the guard clockwise to align the lugs
(8) with the notches (9).
Remove the guard from the tool.
Screw the side handle (2) into one of the
mounting holes in the tool.
Fit the guard as described above.
Place the inner flange (10) onto the spindle
(5) as shown (fig. B). Make sure that the
flange is correctly located on the flat sides of
the spindle.
ENGLISH
11