Dexter 20VSD2-35RCA.11A Mentions Légales & Consignes De Sécurité page 202

Les langues disponibles

4. SCREWDRIVER SAFETY WARNING

Do not touch the bit away after operation. It will be very hot.

Keep your hands away from under the workpiece.

Never use your hands to remove dust, chips or waste close by the bit.

Rags,cloths,cord,string and the like should never be left around the work area.

Support the workpiece properly.

looking up.

When using the tool, use safety equipment including safety glasses or shield. Hearing protection,

and protective clothing including safety gloves. Wear a dust mask if the operation creates dust.

5. SPECIAL SAFETY INSTRUCTIONS FOR BATTERY PACK AND CHARGER

a)This appliance can be used by children aged from 8 years and above and persons with reduced

physical, sensory or mental capabilities or lack of experience and knowledge if they have been

given supervision or instruction concerning use of the appliance in a safe way and understand the

hazards involved.

b)Children shall not play with the appliance. Cleaning and user maintenance shall not be made by

children without supervision.

c) Before the use of the charger and the battery pack, read the instruction manual for it carefully.

d) During the charge process, the current used should correspond to the current of the battery

charger.

e) Never let moisture, rain or splashed water reaches the charging location.

f) The ambient temperature must not exceed 50˚C. Never expose the device to direct insulation.

pulled out of the box.

h) Storage-battery pack, which are defective or damaged or can no longer be recharged, must be

disposed of as

hazardous waste. Hand them over at a special collection point. Never harm our environment. Do

i)If the electrical cable is damaged, the wire may only be replaced by the supplier or by his repair

workshop. Have repairs carried out only by an authorized specialist only.

j) Use only storage-battery pack, which have been produced by the original manufacturer.

k) Always keep the surface of the charger free from dust and dirt.

l) Insert the battery pack into the charger. Follow the guidelines provided concerning polarity.

m) Always remove battery pack before working on the machine

n) When the battery pack is outside the drill, cover the contacts to avoid short circuits (e.g. from

tools)

202