Publicité
Les langues disponibles
Les langues disponibles
3.DRILL SAFETY WARNINGS
1) Safety instructions for all operations
a) Wear ear protectors when impact drilling. Exposure to noise can cause hearing loss.
NOTE:The above warning applies only to impact drills and is omitted for drills.
b) Use the auxiliary handle(s). Loss of control can cause personal injury.
NOTE:The above warning applies only to tools that are provided with auxiliary handle(s).
c) Brace the tool properly before use. This tool produces a high output torque and without
properly bracing the tool during operation, loss of control may occur resulting in personal injury.
d) Hold the power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory may contact hidden wiring. Cutting accessory contacting a
''live'' wire may make exposed metal parts of the power tool ''live'' and could give the operator an
electric shock.
2) Safety instructions when using long drill bits
a) Never operate at higher speed than the maximum speed rating of the drill bit. At
higher speeds, the bit is likely to bend if allowed to rotate freely without contacting the workpiece,
resulting in personal injury.
b) Always start drilling at low speed and with the bit tip in contact with the workpiece.
At higher speeds, the bit is likely to bend if allowed to rotate freely without contacting the
workpiece, resulting in personal injury.
c) Apply pressure only in direct line with the bit and do not apply excessive pressure. Bits
can bend causing breakage or loss of control, resulting in personal injury.
Warning: Harmful and toxic dusts can be produced when you use the tool on hazardous materials.
These dusts can endanger the health of operator and bystanders. Always wear a dust mask
when you work, keep bystanders away from the working area and always use the dust collection
system(not supplied).
4. SCREWDRIVER SAFETY WARNING
Hold power tool by insulated gripping surfaces, when performing an operation where
the fastener may contact hidden wiring.
Fasteners contacting a «live» wire may make exposed metal parts of the power tool «live» and
could give the operator an electric shock.
If possible, always use clamps or a vice to hold your work.
Ensure that the lighting is adequate.
Do not put pressure on the tool, such that it slows the motor down. Allow the bit to screw without
pressure. You will get better results and you will be taking better care of your tool.
Keep the area free of tripping hazards.
Only use accessory bits in good condition.
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
201
Publicité
