Télécharger Imprimer la page

Maytag MDB-1 Guide De L'utilisateur page 3

Publicité

Les langues disponibles

Les langues disponibles

LOADING
Before You Start
Don't prerinse. Simply scrape off any
bones or large food particles.
If connected to a food waste disposer,
make certain the disposer is empty
before starting the dishwasher.
Scrape off tomato-based food soils
(see page 8).
Remove certain foods (such as mus-
tard, mayonnaise, lemon juice, vine-
gar, salt or dressings) from stainless
steel flatware as soon as possible.
These foods may cause rusting and
pitting if allowed to remain in contact
with the surface for an extended peri-
od of time.
Upper Rack
10 Place Settings
Glasses, cups, stemware, light-weight
plastics, small plates, bowls, pans, long-
handled utensils etc. can be loaded in this
rack. Do not load glasses over the tines.
ADJUSTABLE UPPER RACK
(Select models)
General
Recommendations
Place all items in the racks so they
are separated and facing center.
Items can be centered behind a single
tine or loaded at an angle to maximize
space.
Load items so they do not rest over the
top of the wash tower.
Avoid blocking the upper and lower
spray arms by not allowing items to
extend beyond the racks.
The Stack-Rack on the right side of the
upper rack folds up or down for loading flex-
ibility. Fold it down to hold long-handled
knives, spatulas and spoons or short items
like cups or juice glasses. Fold it up for taller
items like glasses, bowls, plates, etc.
The Adjustable Upper Rack can be
raised to accommodate taller plates, plat-
ters, pans, etc. loaded in the lower rack.
To raise the rack:
Pull the rack fully out.
Grasp the handle on the rear right side
of the rack.
Lift and pull the rack slightly forward to
lock up into place.
Recommended Loading
(Rack features vary by model)
For best dishwashing results follow these
guidelines to determine the best arrange-
ment for your items.
The Vari-Lock
Snugger (select models)
on the left secures lightweight items in
place. It can be adjusted by grasping the
wavy wire and rotating it left to snug items
against the outer rack or to the right to rest
on top of light items. Do not load items on
top of the wire.
The wavy wire on the Vari-Lock
(select models) and the Stack-Rack is
designed to hold stemware in place. Taller
stemware will fit better on the right side as
the upper rack is deeper on this side.
To lower the rack:
Pull the rack fully out.
Grasp the handle on the rear right side
of the rack.
Lift and push the rack slightly back to
lock back down into place.
NOTE:
Face soiled surfaces towards the
center of the dishwasher.
Snugger
2

Publicité

loading