Publicité
Les langues disponibles
Les langues disponibles
Available spare parts: Please refer to www.aqua-medic.de.
Fig. 2:
1. Clamp for waste water hose
2. Sealing for clamp
3. Water tap connection (½" internal thread with thread adapter from ½" external thread to M24 external thread)
4. Connection of osmosis system
5. Connection to water tap
2. Set-Up
To install the membrane, the hose must be pulled out of the fitting of the membrane housing (procedure see
below). You pull the membrane housing up out of the clamps, open the screw cap with the help of the enclosed
key, slide the membrane without the transparent packaging with the connector that contains the two O-rings
(Fig. 3, No. 1) first into the membrane housing. Then close and reinsert the hose deep enough.
Take care to insert the membrane in the right direction with both sealings (Fig. 3, No. 1) first. The
membrane has to be pushed forward until the 2 sealings are in the right position at the top and the
pure water sealing is fixed. Before the housing can be closed, check whether the O-ring is mounted
on the module's housing.
Fig. 1:
1. Membrane housing
2. Fine filter
3. Activated carbon filter
4. Flow Restrictor
5. Double clip
6. Pressure gauge
7. Holder pressure gauge
8. Clip membrane housing
9. Suspension
10. Rubber feet
11. Shut-off valve
12. Inlet tap water (red)
13. Connection for osmosis tank (osmosis water
outlet 1/yellow) osmosis tank not included
in delivery
14. Waste water (black)
15. Connection for water tap (osmosis water
outlet 2/blue) water tap not included in
delivery
9
Publicité
