Ford Pro 80A Manuel D'utilisation page 18

AC Charger / AC Chargeur
3.3.2 3.3.2
3.3.2 3.3.2
the wall with appropriate screw. the wall with appropriate screw. the wall with appropriate screw. the wall with appropriate screw.
Follow applicable accessibility requirements for the mounting position.
The unit shall be stored or located at a sufficient height. For indoor site, it
should not be lower than 18 inches (450 mm) and not higher than 4 feet
(1.2m). For outdoor site, it should not be lower than 24 inches (600 mm)
and not higher than 4 feet (1.2m). Refer to Article 625, NEC.
The mounting bracket has ten screw holes. If only two screws be used to
fasten the mounting bracket, the screws should pass through the middle
two screw holes of the mounting bracket. The other screw holes are
reserved for the user.
Figure 3-4 Fasten two screws for wall mount
pedestal mount
Screw sizing suggestion:
A. For masonry walls, use M6 mechanical screws. (Commercially
Available)
B. For finished walls supported by wood studs, use #12 tapping screws.
(Model Accessories)
C. Please refer to the following torque. The actual torque is according to
the wall material.
Secure the main body mounting bracket to Secure the main body mounting bracket
Secure the main body mounting bracket Secure the main body mounting bracket
Screw
M6 25 kgf.cm min
#12 25 kgf.cm min
Ford Pro contact info: chargingsupport@fordpro.com and 1-800-34-FLEET
Canadian Customer Support: 800-668-5515
Installation Manual v2.0 / Manuel d'utilisation v2.0
Figure 3-5 Fasten above screws for
Torque
US Customer Support: 800-343-5338
21.7 lbf-in min
21.7 lbf-in min
to
to to
17