Publicité
7. AIR FLOW DIRECTION ADJUSTEMENT
1.
Status display of air flow/vertical flap
For each press of SWING button
Remote controller :
COOL/DRY :
HEAT :
2.
Left and right air flow adjustment (this function is unavailable on some models).
For each press of swing button
Remote controller :
Cautions :
•
When adjusting the flap by hand,turn off the unit.
•
When humidity is high,condensate water might occur adjusted to left or at air outlet if all vertical
louvers are right.
•
It is advisable not to keep horizontal flap at downward position for a long time in COOL or DRY
mode, otherwise, condensate water might occur.
Note :
When restart after remote turning off, the remote controller will automatically memorize the previous
set swing position.
8. SLEEP MODE
Press SLEEP button
Press again this button
8.1. Operation mode
1.
In COOL, DRY mode
1 hours after SLEEP mode starts, temperature will become 1°C higher than temperature setting.
After another 1 hour, temperature rises by 1°C further. The unit will run for further 6 hours then stops
temperature is higher than temperature setting so that room temperature won't be too low for your
sleep.
AIR
, remote controller displays as follows :
Initial state
AIR
, remote controller displays as follows :
, the remote controller will show
, the sleep function will be cancelled.
SLEEP operation starts
1 hr
Rises 1 °C
1 hr
Temperature setting
In COOL, DRY mode
. and then achieve to the sleep function.
SLEEP operation stops
Approx.6hrs
Rises 1 °C
Unit stop
43
Publicité
