Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Dishwashers may occasionally exhibit problems that are
unrelated to a malfunction of the dishwasher itself. The
following information may help you with a dishwasher
problem without involving a repair professional.
Note: If the appliance stops during dishwashing or does
not start for any obvious reason, first run the cancel wash
cycle function (Reset).
WARNING
9
IMPROPER REPAIRS OR USE OF NON-ORIGINAL
REPLACEMENT PARTS MAY CAUSE
Fault
"
‚‰
Error code
:
is lit.
"
‹ˆ
Error code
:
is lit.
"
ƒƒ
Error code
:
is lit.
"
ƒ...
Error code
:
is lit.
"
Ġ
Error code
:
is lit.
"
ƒˆ
Error code
:
is lit.
A different error code is indi-
cated on the digital display.
"
‹‚
"
„‹
(
:
to
:
)
@
Refill indicator for salt
8
and/or rinse-aid
is lit.
@
Refill indicator for salt
8
and/or rinse-aid
is not lit.
Water is left in the appliance
at the end of the wash cycle.
38
Cause
Supply hose kinked.
Tap turned off.
Tap jammed or calcified.
Intake opening (on right inside of
appliance) covered by dishes.
1b
Filters
are soiled or blocked.
Waste-water hose kinked or
blocked.
Siphon connection still sealed.
Cover on the drain pump loose.
Drain pump blocked or cover on the
drain pump is not locked in posi-
tion.
Supply voltage too low.
A technical fault has probably
occurred.
No rinse aid.
No salt.
Sensor does not detect salt tablets. Use different special salt.
Refill indicator switched off.
There is still enough special salt/
rinse aid available.
Filter system or area under the fil-
1b
ters
is blocked.
Wash cycle has not ended yet.
CONSIDERABLE DAMAGE AND PUT THE USER
AT CONSIDERABLE RISK
Always have repairs carried out by authorized
technicians. If a component has to be replaced,
always use original replacement parts.
Error message
Some faults are indicated at the top of the display
H
window
and on the front display *
remedies are offered (for example Filter system soiled
(E22) -->Clean filters).
* optional feature which may or may not be included with
your dishwasher.
Fault table
Remedial action
Install supply hose without kinks.
Turn on the tap.
Turn on the tap.
Flow rate must be min. 10 l/min. when water
supply is open.
Arrange dishes so that the intake opening is
not obstructed.
Clean filters.
Install hose without kinks, remove any residue.
Check connection to siphon and open if
required.
Lock cover correctly.
Clean pump and lock cover correctly.
Not an appliance fault, have the mains voltage
and electrical installation checked.
Switch off appliances with the ON/OFF switch
(
. After a short time restart the appliance.
If the problem recurs, turn off the tap and pull
out the mains plug.
Call customer service and mention the error
code.
Refill rinse aid.
Refill with special salt.
Activation/deactivation.
Check refill indicator, levels.
Clean filters and area underneath.
Wait until wash cycle ends or reset.
):
and possible
Publicité
