SPECIFICATIONS
Range . . . . . . . . . . Up to 30 ft. (9.1 m)
Sensing Angle . . . . Up to 180°
Electrical Load . . . . See rating on fixture for
Sensor Capacity . . Up to 360 Watt (3.0
Power
Requirements . . . . 120 VAC, 60 Hz
Operating Modes . . T E S T, AU TO, a n d
Time Delay . . . . . . 1, 5, 10 minutes
D
B
®
ual
rite
HeathCo LLC reserves the right to discontinue
products and to change specifications at any
time without incurring any obligation to incorpo-
rate new features in products previously sold.
SYMPTOM
Light will not
come on.
Light comes on
in daylight.
598-1167-05
Get user manuals:
See SafeManuals.com
[varies with surrounding
temperature].
maximum wattage.
A.) Maximum Tungsten
Incandescent
MANUAL MODE
timer . . Off, 3, 6 hrs, Dusk-to-
Dawn
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE
1. Light switch is turned off.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect
(recheck after dark).
5. Incorrect circuit wiring, if this is
a new installation.
1. Light control may be installed
in a relatively dark location.
2. Light control is in Test. (Set
control switch to an ON-TIME
position.)
SYMPTOM
POSSIBLE CAUSE
Light comes
1. Light control may be sensing
on for no ap-
small animals or automobile
parent reason.
traffic (Reduce sensitivity).
Light stays on
1. The sensor is pointed toward
continuously.
a heat source like an air vent,
dryer vent, or brightly-painted
heat-reflective surface. (Reduce
sensitivity.)
2. Light control is in Manual Mode.
(Switch to Auto.)
3. Light control is in D
mode.
4. Sensitivity is set too high. (Re-
duce sensitivity.)
Light flashes
1. Light control is in the Test
on and off.
m o d e a n d wa r m i n g u p.
(Flashing is normal under these
conditions).
7
B
®
ual
rite